Question: | can this be used for 110v in an RV? or only used for 12v wiring? |
Answer: | The wire is rated for 600 volts. It would work just fine for 110v wiring in an RV. Also a standard wall outlet is rated for less than how much current this wire can carry, so there's no issues there either. |
|
Question: | Can i use this gs power’s 16 ga to power 150w light bar ? or should i go with 14 awg? |
Answer: | depends on how long you running the wire. Typically we target a 2% voltage drop in automotive syytems. With a 12V battery supplying 150W, 5 ft will be ok (a voltage drop of ~0.4V). But if you are running more than 10 ft, we would use 14AWG |
|
Question: | Is this flexible (# strands?), i want to run this in my attic (florida), temps could get as high as 150 f. used for 12v cameras/lights under eaves? |
Answer: | Yes, It's very flexible. 67 strands (each strand is 30 gauge). Can easily handled 150 F. But 12 AWG might be overkill for 12v Camera. We have smaller gauge wires available at www.amazon.com/gspower |
|
Question: | Can this be used for 120v AC current? |
Answer: | Not intended (also not approved) for household 120V/240V AC. DC only. |
|
Question: | is this wire an over kill for outdoor patio speaker wire ? |
Answer: | for typical speaker, 14 or 16 AWG should be sufficient. visit www.amazon.com/gspower for other options |
|
Question: | Can you use this for speakers ? |
Answer: | absolutely, best wire available |
|
Question: | What is the maximum amp rating of this cable (continuous)? |
Answer: | according to my sheet 12G wire is good for 30 Amps Max If your anticipated load is very close to that I would go to 10G wire |
|
Question: | With my custom build caamper trailer will this meet all the needs of 12 volt up to 15 amps. reading lamps, rv 12 volt atwood furnace, out side entry l |
Answer: | Hello James,
Thanks for your question and for your interest in our product.
To answer your question, yes, this should be fine since the wire is rated for up to 15 Amp maximum.
We hope this helps. Thanks again for reaching out to us.
All the best,
Eyz
GS Power Customer Obsession Champion
|
|
Question: | Which Underwtiters Laboratory standard does this wire meet ? As noted in specifications |
Answer: | I don't know. If it doesn't have it printed on the insulation then none. I only used it for DC voltage. |
|
Question: | Will this wire work with a 4 pin trailor wiring harness? |
Answer: | I guess that depends on how you use it. This is ONLY a 2 wire conductor (Black and red) I suppose if you cut it and use 2 pieces for the 4 pin it could work but that would make it confusing as you have 4 wires with 2 sets of the same color. Other than that detail, Yes I suppose it could work |
|
See more questions |
Comments
Post a Comment