[Review&QnA] SYMIK A310-MA2 Waterproof Hard Carrying Case for DJI Mavic Air 2 / Air 2S Drone / Fly More Combo; Rugged Professional Case with Complete Protection


Electronics > Camera & Photo > Bags & Cases > Camcorder Cases

[Review&QnA] SYMIK A310-MA2 Waterproof Hard Carrying Case for DJI Mavic Air 2 / Air 2S Drone / Fly More Combo; Rugged Professional Case with Complete Protection
GotoProduct
About this item
  • 【Quality Material】Precisely cut foam insert with Professional Grade Red Closed Cell Crosslinked Polyethylene Foam top surface which resists water and dust infiltration. Also provides a professional looking
  • 【Complete Protection】Designed to provide Superior protection to your investment. For example the remote controller can be stored up side down so you don't need to take the control sticks off while receiving best protection. Or if you prefer a formal looking, you can store it upright but it is recommended to take the control sticks off in this position; Special Slot designed for the long fragile Charging Hub; Extra deep and soft top sponge for gentle but secure hold
  • 【Flexibility】Designed to maximize storage possibilities: An open storage area with cut out foam piece included provides you with options to fit your special gears. You can cut the foam piece for your storage needs or just take it out for maximum flexibility. You can also use this big trunk of foam to Adjust any special fitting needs you may have for your gears
  • 【Holds A Bunch】Designed to be able to hold everything in the Mavic Air 2 Fly More Combo and a lot more: 2 more batteries, DJI car charger, extra DJI filter sets, Micro SD Cards etc. Case exterior dimension is approximately 13.3 x 12.4 x 4.9 inches or 335 x 310 x 125 mm. Can be fitted into most standard sized backpacks
  • 【Instructions and Tips】(1) If you feel the DJI Air 2S fits a little bit too tight, you can try to cut 3/16" off the foam in front of the drone (Flat area) with a razor blade. (2) If you have difficulty opening the case, please turn the round knob near the handle counter-clockwise to release the air pressure; tighten back after opening (3) How to take out the rectangular pre-cut piece: Take the entire foam insert out of the case first, then you can push the rectangular piece out from the bottom

Review

A well-built case!
Size: Medium | Verified Purchase
After selling my Anafi and upgrading to the Mavic Air 2, I was looking around for a case to replace the cheap Harbor Freight case I used on my previous drone. I saw this, and since I didn't have the smart controller, thought this might fit the bill for protecting my new investment. The case is a solid choice for the Mavic Air 2.

Pros:
1. Slim - the case is no bigger and no smaller than it needs to be. Makes travel with my drone easier since it takes up less room in the car with my family + two dogs.
2. Precision cutouts - When they said these cutouts (for the batteries, controller, drone, etc) were precision cut, they really meant it. The fit on everything is snug without being problematic.
3. Tough plastic - the case material itself is tough as any other case you might find out there. I dropped it a few times (on accident) from a few feet above onto concrete and only managed to slightly scuff the corner where it hit.

Cons
1. Price - for the price I paid, you might get an equally solid case for your drone with a few more bells and whistles (such as optional cutouts for the regular controller AND the smart controller).
2. It does not do my taxes
 
Instant five star review
Verified Purchase
I'm using this for a DJI Air 2S with the Smart Controller. I haven't even fully sorted out how I am going to configure this, but I don't need to sort that out before taking time to give this a five star review. I am thoroughly, thoroughly pleased with this product! It's pretty ingenious how they cut the foam so many different ways to give you the option to use the case with a variety of accessories.

Considering how thoughtfully designed and useful this item is, I am mildly disappointed that the space they carved out specifically for the ND filters will not work with the Air 2S filters. The case is too large. Oh well. I'm sure I will find somewhere else to put the filters. The other quibble I have is that it was rather difficult to remove the insert from the storage location of the 6th battery. I ended up tearing that up so badly, I just trashed it. The other foam pieces left over, I'm saving, because I might end up wanting to reconfigure the case in the future, and that is definitely an option.

I have no idea how they cut the foam to make this. A water jet maybe? The cuts are very precise and clean. The foam is very dense, and I feel like it will provide excellent protection. The case itself has a very sturdy, solid feel, and I have little doubt that it will hold up to life's bumps and thumps handily.

It has been a long time since I got this excited about a product. If this product is representative of the kind of things these folks design and manufacture, then SYMIK is definitely a brand to watch.
 
Amazing case!
Verified Purchase
Just got this SYMIK P380-MA2DL Dual Layer Case, the folding landing pad and retractable landing gear from Amazon for my new Mavic Air 2 Flymore kit. It's like a puzzle where you can add & remove the foam fillers to put in anything you need. I got my entire FlyMore kit, my MavMount, my iPad mini, the landing pad and more with places to spare for more "stuff." I accidentally found this case on YouTube looking at reviews of drones. Was just about to get a different one but the "bottom storage" clinched the deal. The reviewer said this case was a "hidden gem" and he was correct. There was another similar case by a German company for about 3X the price and virtually identical. If there was just one minor little I could come up with it is that there is no provision for a shoulder strap.
 
Outstanding case - has a big plus over other designs.
Size: Medium | Verified Purchase
Outstanding case. Very well built, foam cutouts are exact. The drone and accessories fit snugly. One thing that makes this case standout is the cutout underneath the controller. First, you can store the controller face down with the sticks attached (a HUGE plus) and there is extra storage under there as well. I stored the extra blades and the extra controller/phone cables. I have two batteries so I am using some of those compartments for some other accessories I have.
 
Best case for the money and fits Air 2S and more.
Verified Purchase
Great case because it can adapt.
I have the DJI Air 2S Combo, DJI phone hood, 7" Galaxy S2 tablet (works great), folding tablet holder from the VFW store on Amazon, and landing pad by ACROTOR from Amazon. I also have the extended data cable for my tablet from the Hanatora Store on Amazon. DJI for some reason is happy to sell a tablet holder but they do not have longer USB cables...I asked.

I took out all but the last two layers in the bottom of the case and it fits my tablet, phone hood (plastic bracket up) and extra props. Yes I even put extra props under the remote controler since it has removable blocks. I folded up my landing pad and put on the right side. It fits snug but not damaging. Good enough for taking on a plane trip. Otherwise I'll just use a small carabiner for the lading pad bag. I have room for two more batteries if I leave one installed the aircraft for short periods of time.
 
The perfect case for your DJI Air 2S drone! (UPDATE)
Verified Purchase
I am a brand new drone pilot and after looking at other expensive drone cases and suggested cases more than $100.00 this serves the purpose. and it's less than $100.00

The only thing I would like to see improved is maybe a hidden storage compartment on the top side of the case for storage of important flight documents & your log & maintenance books and maybe additional blades. I like the pouch for storing your blades too. Very nice!

I also like the cardboard explaining the various places of storage. Even small slits for additional storage of your micro-SD card.

Keep in mind that you will need to remove the additional foam for your Air 2S controller to fit. I am overly pleased with this.

I wanted to update my review. There IS additional storage under the area for the drone. Just lift up and there you have it. See the last image. This is GREAT
 
Best Value for my DJI Air2S ...it really is.
Size: Medium | Verified Purchase
What a great case for my DJI AIR2S. For the price and functionality, it is hard to beat. I was able to neatly fit EVERYTHING for my drone inside:
The DJI Air2S;
The Controller;
5 Batteries;
Power Bank Converter w/cables;
Battery Charging Hub;
ND Filter Set;
6 sets of extra blades;
and more.
There are foam inserts that you can remove to accommodate any extra items.
Also included is a large pictorial diagram suggesting which foam pieces should be removed to accommodate the model you have. (Mavic Air 2 or DJI Ais 2S). A lot can fit securely inside while being protected. There's a removable solid foam protector piece in the bottom of the case and another one in the lid.
Its obvious that this company takes pride in their products and they want you to be 100% satisfied. I am.
 
Stores all safely for easy use
Verified Purchase
I looked at every case available for the DJI Air2S. This one met all my requiremensts plus more. I have all the whistles and bells for the Air2S and wanted a case to organize and carry every item. This case came with a large layout description that helps utilization of every nook and cranny. The foam is firm to support everything with being a coarse hard foam. These guys must use the cases themselves as the engineering is superb the case is rigid and the closing and locking system is as good as it gets.
I would buy it again and recommend it to everyone with a DJI Air2S with the standard control or the premium control. Phil
 
Seriously a perfect case
Size: Medium | Verified Purchase
This case is super nice and much better than the one that comes with the fly more combo. I like knowing that if I drop the case it’s probably not going to hurt the drone or the other stuff inside it. I honestly can’t think of anything I would change about it other than maybe a spot for an iPad but since I don’t use the iPad for flying anyway I guess even that doesn’t make a ton of sense. So yeah....buy it if you have the Mavic Air 2. You won’t regret it.
 
Great case!
Verified Purchase
 Excellent case! I have 2 other cases, one for my mini 2 and another for my Mavic Air 2. I got this case for the Air 2S and the Smart Controller. The only slight downside to this case might be its size. Compared to my other cases, it is much larger/heavier. If you have alot of accessories and a Smart controller then this is definitely the case to get, otherwise you might need something smaller.
 
See more reviews

Custom Questions & answers

Question:I like the feature that I can store the remote controller up side down, but is the top foam deep enough to hold the remote from moving?
Answer:Hi, Thank you for your interest in the Case. Yes, the top egg crate shape sponge is made of top grade material, it is deep and soft to provide a gentle but secure hold to the case contents. What's more important, unlike many Mavic air 2 cases on Amazon, we added a cushion piece at the bottom of the remote controller compartment to elevate the remote so that the top sponge can hold the remote in place securely in either way (Face up or down). We bench marked many Mavic Air 2 cases on the market. Many of them use very shallow sponge with small crates. They don't provide a cushion to elevate the remote controller either. They typically cannot hold the remote controller in place very well. So again, to answer your question, yes, when you place the remote upside down, the top sponge is able to hold the remote from moving.
 
Question:Will you have a version to fit the new rc pro controller that's now included in the air 2s bundle?
Answer:Yes, we are working on revising our current design to fit the DJI RC PRO. But the newly designed case will only be available in about 3 months due to the congestions at the Los Angeles/Long Beach port. Thank you for your interest!
 
Question:Will the samsung galaxy tab s7 fit in the case?
Answer:Yes the Galaxy Tab S7 will fit. The lower storage compartment has remove inserts that you can remove to fit larger tablets.
 
Question:Is there a shoulder strap available for this case?
Answer:It will be available in about 1.5-2 months. See the link for the padded adjustable shoulder strap
https://www.amazon.com/dp/B08R8Y79L6
 
Question:Can i purchase an extra set of foam inserts?
Answer:Hi, We currently do not sell just the foam inserts for the case. Is there anything wrong with the case that you have? You can always feel free to contact us via Amazon message with your order number and we are here to assist you.
 
Question:Can the ronin rsc2 fit at the bottom?
Answer:No the Ronin will not fit in the bottom. The bottom storage area was design to fit a tablet or a folding landing pad only.
 
Question:Can this fit dji mavic air 2 with symik extension landing gear installed ?
Answer:Yes if you are using our SYMIK Landing Gear Extension set you can leave the landing gears install and have no issues fitting in the case.
 
Question:Is the large rectangular piece of foam pre-cut, or does the customer have to get a knife and cut it himself?
Answer:All of the compartments are already pre-cut so you can simply pull out the foam piece. There is no need to cut anything. -Sure RC
 
Question:Dose it come with the drone itself?
Answer:No. It does not come with the drone. The drone itself will cost about $1000 USD. This is a really nice case though and glad I purchased it.
 
Question:What charging hub fits in here?
Answer:The SYMIK case is designed to fit the OEM DJI Charging Hub.
 
See more questions

Comments